Home Order Catalog Online Catalog New Items Contact Us

i
WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**
157
Steering – Typical: '60-69 CARS
PICTURE # – REFER TO PICTURE DIAGRAM PAGE 156.
9. Tie Rod Clamp: 4 needed (order BOLTS separately #6, page 156)
Replacement (used in kits) C181A 4 oz.
Exact Repro (not included in any kits) C181AX 4 oz.
10. Tie Rod Sleeve:
Joins the tie rods. Always replace when doing tie rods.
STEEL: C181 1 lb.
11. INNER TIE ROD ENDS
Year CLARK Repro
1960-62 C951R 1 lb.
1963-64 C951R 1 lb.
1965-69 left threads C3140 1 lb.
Either side.
Check yours for
looseness.
SLOTTED NUT: C726 2 oz.
GREASE FITTINGS: See #8, page 156
COTTER PIN: SET of 5 – C726A (A little small for some tie rods). 1 oz./Set
SET of 5 – C2199 (A little big for some tie rods). 1 oz./Set
STAINLESS COTTER PINS
Sold SET OF 5
C3106 1 oz./Set
1961-65 FC (Van) STEERING
BUSHINGS – front A-arm
NYLON PERFORMANCE BUSHINGS – see pg. 167B
Upper Bushing – 2 needed per side C4907 8 oz. ea.
Lower Bushing – 2 needed per side C3070 8 oz. ea.
SHAFT-A-ARM
BOLTS – see page 180
FRONT LOWER INNER A-ARM SHAFT
All FC (Vans) either side. Wears where the
bushing pivots. C2098H 4 lbs. ea.
Steering Box
"NUT", Lower Control Rod to Suspension: 2 needed. (2) 7/16"bolt thread in. C12872 6 oz. ea.
BUSHING WASHERS – UPPER & LOWER: I.D. a little big for upper. EXACT for lower. (4) needed per side. C4617 4 oz.
BOLTS: For ends of front bushings. 1 needed per side (each incl. 2 bolt & 2 lw).
UPPER BUSHING BOLT: C4756 2 oz. LOWER BUSHING BOLT: C4757 2 oz.
BUMPER: on crossmember below control arm. C4615 6 oz. ea.
VAN Ball Joints – page 151
Shocks – pages 137-139
Springs – page 140
PICTURE #
1. OUTER TIE ROD ENDS - Either side
Note: Outer 1963-64 Non-GM will NOT work with inner original Chevy (order inner & outer Non-OriginaI).
2. TIE ROD SLEEVE: C181 1 lb.
3. IDLER ARM: 1961-65 – Slightly different from original. Has grease fitting. C1614 5 lbs.
NUT: Idler arm to drag link C2144 2 oz. (BOLTS: Below to right)
4. TIE ROD CLAMP: 4 needed C181A 2 oz. ea.
BOLT KIT: (bolt, lock washer, nut) “Gr 5”: C2146 2 oz./kit "Gr 8": C2147 2 oz./kit
5.
INNER TIE ROD ENDS
$$ SAVER TIE ROD ENDS – 61-65 Vans (FC)
1965 Vans used equal length tie rod ends. Sleeves were same as on 61-64 Vans. Used as a pair, can be used on one side or both sides of the 61-64 Vans.
PAIR (1) left & (1) right TIE ROD ENDS: C10772 (1) PAIR 4 lbs.
Same as C10772 BUT ADDS (2) clamps, (2) "Gr 8" bolt kits to the (2) TIE ROD ENDS: C10773 4 lbs. 12 oz.
FULL SET-UP FOR 1 SIDE: PAIR of left & right tie rod ends, new sleeve, (2) new clamps, (2) "Gr 8" bolt kits. C10774 5 lbs. 12 oz.
6. "RELAY ARM" (Boomerang shaped): USED units are inspected and REBUILT (we replace inner rubber, nylon, stud, cap & reweld). Your USED one only has a core value
if it is rebuildable (we include instructions on how to test your old one). Price INCLUDES core value. C1615R 8 lbs.
BRACKET FOR ARM: CX4746 3 lbs. BOLTS FOR BRACKET: C4767 6 oz./set
7. SUBSTITUTE STEERING LINK: From steering box pitman steering arm. The original 15" rod is not available. By machining
a longer connecting sleeve and finding "exact" replacement ends, we can offer you a complete replacement unit.
(2) ends, special sleeve, clamps, bolts. ALSO SEE 7½. C2372 5 lbs.
COTTER PINS: Set of 5 C726A 2 oz./Set STAINLESS COTTER PINS: Set of 5 C31O6 2 oz./set
7½. ORIGINAL SHORT END: #7½ in diagram. Must be used with original “tie rod” sleeve. This CANNOT be used with #7 (C2372)
above. We cannot supply #8 (long end). 1961-65 ORIGINAL STYLE SHORT END: C7544 2 lbs.
8. USED COMPLETE CONNECTOR ROD (Pitman arm to Boomerang): See USED page 365
9. RUBBER BOOT (SEAL): Steering link ends (fit original or replacement). C13048 2 oz. ea.
1O. NUT: Used at both ends of steering link. Sold each. C2403 2 oz. ea.
OUTER TIE RODS
Year NON-GM
1961-64 Van (FC) C4593 1 lb.
1965 Van (FC) C4742R 1 lb.
Year NON-GM
1961-64 Van (FC) C4744AR 1 lb.
1965 Van (FC) C4743R 1 lb.
4
BOLTS: Attach idler arm to frame
Sold as Set
C6856 6 oz./set
STABILIZER BARS – SEE PAGE 167B
6 oz.
– NEW REPRO
C1615R
MULTI-KITS
see Blue pg. MK-12, pg. MK-13
C181A
C181AX
C8490
C1665A
iWARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**157Steering - Typical: '60-69 CARSPICTURE # - REFER TO PICTURE DIAGRAM PAGE 156.9. Tie Rod Clamp: 4 needed (order BOLTS separately #6, page 156) Replacement (used in kits) C181A 4 oz. Exact Repro (not included in any kits) C181AX 4 oz.10. Tie Rod Sleeve: Joins the tie rods. Always replace when doing tie rods. STEEL: C181 1 lb. 11. INNER TIE ROD ENDSYear CLARK Repro1960-62 C951R 1 lb.1963-64 C951R 1 lb.1965-69 left threads C3140 1 lb.Either side. Check yours for looseness.SLOTTED NUT: C726 2 oz.GREASE FITTINGS: See #8, page 156COTTER PIN: SET of 5 - C726A (A little small for some tie rods). 1 oz./Set SET of 5 - C2199 (A little big for some tie rods). 1 oz./SetSTAINLESS COTTER PINS Sold SET OF 5C3106 1 oz./Set1961-65 FC (Van) STEERINGBUSHINGS - front A-arm NYLON PERFORMANCE BUSHINGS - see pg. 167B Upper Bushing - 2 needed per side C4907 8 oz. ea. Lower Bushing - 2 needed per side C3070 8 oz. ea. SHAFT-A-ARM BOLTS - see page 180 FRONT LOWER INNER A-ARM SHAFT All FC (Vans) either side. Wears where the bushing pivots. C2098H 4 lbs. ea.Steering Box"NUT", Lower Control Rod to Suspension: 2 needed. (2) 7/16"bolt thread in. C12872 6 oz. ea.BUSHING WASHERS - UPPER & LOWER: I.D. a little big for upper. EXACT for lower. (4) needed per side. C4617 4 oz.BOLTS: For ends of front bushings. 1 needed per side (each incl. 2 bolt & 2 lw). UPPER BUSHING BOLT: C4756 2 oz. LOWER BUSHING BOLT: C4757 2 oz. BUMPER: on crossmember below control arm. C4615 6 oz. ea.VAN Ball Joints - page 151 Shocks - pages 137-139 Springs - page 140PICTURE #1. OUTER TIE ROD ENDS - Either side Note: Outer 1963-64 Non-GM will NOT work with inner original Chevy (order inner & outer Non-OriginaI).2. TIE ROD SLEEVE: C181 1 lb. 3. IDLER ARM: 1961-65 - Slightly different from original. Has grease fitting. C1614 5 lbs. NUT: Idler arm to drag link C2144 2 oz. (BOLTS: Below to right)4. TIE ROD CLAMP: 4 needed C181A 2 oz. ea. BOLT KIT: (bolt, lock washer, nut) "Gr 5": C2146 2 oz./kit "Gr 8": C2147 2 oz./kit5. INNER TIE ROD ENDS$$ SAVER TIE ROD ENDS - 61-65 Vans (FC)1965 Vans used equal length tie rod ends. Sleeves were same as on 61-64 Vans. Used as a pair, can be used on one side or both sides of the 61-64 Vans. PAIR (1) left & (1) right TIE ROD ENDS: C10772 (1) PAIR 4 lbs.Same as C10772 BUT ADDS (2) clamps, (2) "Gr 8" bolt kits to the (2) TIE ROD ENDS: C10773 4 lbs. 12 oz.FULL SET-UP FOR 1 SIDE: PAIR of left & right tie rod ends, new sleeve, (2) new clamps, (2) "Gr 8" bolt kits. C10774 5 lbs. 12 oz.6. "RELAY ARM" (Boomerang shaped): USED units are inspected and REBUILT (we replace inner rubber, nylon, stud, cap & reweld). Your USED one only has a core value if it is rebuildable (we include instructions on how to test your old one). Price INCLUDES core value. C1615R 8 lbs. BRACKET FOR ARM: CX4746 3 lbs. BOLTS FOR BRACKET: C4767 6 oz./set7. SUBSTITUTE STEERING LINK: From steering box pitman steering arm. The original 15" rod is not available. By machining a longer connecting sleeve and finding "exact" replacement ends, we can offer you a complete replacement unit. (2) ends, special sleeve, clamps, bolts. ALSO SEE 7 1/2 . C2372 5 lbs. COTTER PINS: Set of 5 C726A 2 oz./Set STAINLESS COTTER PINS: Set of 5 C31O6 2 oz./set7 1/2 . ORIGINAL SHORT END: #7 1/2 in diagram. Must be used with original "tie rod" sleeve. This CANNOT be used with #7 (C2372) above. We cannot supply #8 (long end). 1961-65 ORIGINAL STYLE SHORT END: C7544 2 lbs.8. USED COMPLETE CONNECTOR ROD (Pitman arm to Boomerang): See USED page 3659. RUBBER BOOT (SEAL): Steering link ends (fit original or replacement). C13048 2 oz. ea. 1O. NUT: Used at both ends of steering link. Sold each. C2403 2 oz. ea.OUTER TIE RODSYear NON-GM1961-64 Van (FC) C4593 1 lb.1965 Van (FC) C4742R 1 lb.Year NON-GM1961-64 Van (FC) C4744AR 1 lb.1965 Van (FC) C4743R 1 lb.4BOLTS: Attach idler arm to frameSold as SetC6856 6 oz./setSTABILIZER BARS - SEE PAGE 167B6 oz.- NEW REPROC1615RMULTI-KITSsee Blue pg. MK-12, pg. MK-13C181AC181AXC8490C1665A
Search In Corvair Catalog Content
CLARKS- MORE THAN PARTS.

Copyright © 1978, 2022 Clark's Corvair Parts, Inc., "Clark's Corvair Parts" and the "Corvair Map" are registered service marks of Clark's Corvair Parts, Inc.
400 Mohawk Trail Shelburne Falls, MA 01370 USA All rights reserved.
Main Office Phone: 413.625.9776 Fax: 413.625.8498