Home Order Catalog Online Catalog New Items Contact Us

i
WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**
69
New Gas Tanks: 1961–69 Cars
Gas tanks usually rust from the inside and start to leak. These are EXACT REPROS made from "GAS TANK STEEL" that Is thicker than
the originals. Pressure tested, wrapped and boxed. SEE FOR OTHER ITEMS USUALLY NEEDED.
196169 Car Gas Tank C151 40 lbs. (due to size)
New FC Gas Tanks
Plated steel gas tanks. These will fit all 196165 FCs. Other tank Installation parts sold
separately or see multi-kits (page MK-4).
196365 Note: 6365 FC w/ PG transmission did not have "hole" in tank.
196165 w/ NO hole for shifter C11710N 67 lbs. (due to size)
196365 with hole for shifter C11710H 67 lbs. (due to size)
FC sender note: 1963-65 with hole through tank - you must use the “64-65 FC” sender unit; the 61-63 will not fit.
1964-65 FC with PG (using a tank with no hole) should still order the 64-65 sender as it “goes” with the dash gauge.
Gas Tank Sealer: It is resistant to all alcohol blended fuels and adheres even
tighter to metal and rust. It remains flexible and stays on even if tank is dented. If tank has extreme rust, have it
professionally cleaned. If tank has minor rust, just dry and seal. (Tank must be removed. Allow minimum of 2 days to
dry). Do not use rust preservers in tank first. 1 can will seal a car or FC tank with 2 coats. There are no finer sealers
available. We highly suggest you seal any NEW tank. —MORE INFO: Page 66
Sold in Quarts C9390 3 lbs.
Por-15 Sealer Quart C11133 3 lbs.
Instant Gas Tank Repair Patch: Instantly seals small holes up to ¼" in gas tank without draining. Sticks to "gas wet" metal. Clean area, tear off piece
and knead. Push patch into and around the hole. Sets in 5 minutes. Great to keep in all terrain vehicles.
Loctite C5782 4 oz.
Parts you should definitely consider as they are usually needed to replace or even remove a tank.
1. Holder/Retainer: The round steel ring that wedges the gas gauge against the gasket.
Usually old one is rusty. 196169 C156 4 oz.
Special Bolts with Nylon Seal: Holds 1960 gas sender units in tank. Sold Set of 5. C3824 2 oz./set
Gas Sender Unit REMOVER TOOL: Easily install and remove gas tank sender retainer ring,
even with tank in car. (Also works on 196182 Chevy, Corvette & Camaro!)
196169 Corvairs C7264R 1 lb.
2. Gas Tank Gauge Unit: Stainless except for a few brass & plastic par ts. Complete with float and wire.
Screen (filter) not included. Order screen, retainer & gasket.
FC – Read note below new tanks.
1960 Cars C12801 1 lb.
196164 Cars C846 1 lb.
1961-63 FC C12802E 1 lb.
196465 FC C12802 1 lb.
196569 C ars C847 1 lb.
2A. Gas Tank Strainer : 196065 Cars & Vans according to the Parts Book but
suggested for 6669. Fits on end of gas line inside tank, exact fit. C261 2 oz.
2B. Gas Tank Sender Unit Float: Slightly different size but fits and works for ALL Corvairs. C846F 4 oz.
2C. Gas Tank Sender Ground Screws : If your gauge isn't working, it might be due to a poor ground.
196069 Original Size C5177 1 oz.
196069 Oversize for rusted or stripped holes C5178 1 oz.
3. Gauge "Gasket" Seal : 196169 rubber seal for tank gauge unit. Replace each time removed.
196169 Seal C155 2 oz.
1960 Sender Unit Gasket C3823 1 oz.
4. Strap: Just this one steel strap holds the tank up!
196069 Cars: EXACT REPRO C153E 2 lbs.
196069 Cars: Good repro C153R 2 lbs.
196165 Vans: Good repro (2 needed) C4307 2 lbs.
Repro Gas Tank & Parts
Low Fuel Warning
See page 98B
Steel Gas Lines:
See pages 67–68
C261
C155
C7264R
C156
MULTI-KITS
see Blue pg. MK-4
iWARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**69New Gas Tanks: 1961-69 CarsGas tanks usually rust from the inside and start to leak. These are EXACT REPROS made from "GAS TANK STEEL" that Is thicker than the originals. Pressure tested, wrapped and boxed. SEE ? FOR OTHER ITEMS USUALLY NEEDED. 1961-69 Car Gas Tank C151 40 lbs. (due to size)New FC Gas TanksPlated steel gas tanks. These will fit all 1961-65 FCs. Other tank Installation parts sold separately or see multi-kits (page MK-4). 1963-65 Note: 63-65 FC w/ PG transmission did not have "hole" in tank. 1961-65 w/ NO hole for shifter C11710N 67 lbs. (due to size) 1963-65 with hole for shifter C11710H 67 lbs. (due to size)FC sender note: 1963-65 with hole through tank - you must use the "64-65 FC" sender unit; the 61-63 will not fit. 1964-65 FC with PG (using a tank with no hole) should still order the 64-65 sender as it "goes" with the dash gauge. Gas Tank Sealer: It is resistant to all alcohol blended fuels and adheres even tighter to metal and rust. It remains flexible and stays on even if tank is dented. If tank has extreme rust, have it professionally cleaned. If tank has minor rust, just dry and seal. (Tank must be removed. Allow minimum of 2 days to dry). Do not use rust preservers in tank first. 1 can will seal a car or FC tank with 2 coats. There are no finer sealers available. We highly suggest you seal any NEW tank. --MORE INFO: Page 66-- Sold in Quarts C9390 3 lbs. Por-15 Sealer Quart C11133 3 lbs.Instant Gas Tank Repair Patch: Instantly seals small holes up to 1/4 " in gas tank without draining. Sticks to "gas wet" metal. Clean area, tear off piece and knead. Push patch into and around the hole. Sets in 5 minutes. Great to keep in all terrain vehicles. Loctite C5782 4 oz.? Parts you should definitely consider as they are usually needed to replace or even remove a tank. ?1. Holder/Retainer: The round steel ring that wedges the gas gauge against the gasket. Usually old one is rusty. 1961-69 C156 4 oz. Special Bolts with Nylon Seal: Holds 1960 gas sender units in tank. Sold Set of 5. C3824 2 oz./set Gas Sender Unit REMOVER TOOL: Easily install and remove gas tank sender retainer ring, even with tank in car. (Also works on 1961-82 Chevy, Corvette & Camaro!) 1961-69 Corvairs C7264R 1 lb.2. Gas Tank Gauge Unit: Stainless except for a few brass & plastic par ts. Complete with float and wire. Screen (filter) not included. Order screen, retainer & gasket. FC - Read note below new tanks. 1960 Cars C12801 1 lb. 1961-64 Cars C846 1 lb. 1961-63 FC C12802E 1 lb. 1964-65 FC C12802 1 lb. 1965-69 C ars C847 1 lb.2A. Gas Tank Strainer : 1960-65 Cars & Vans according to the Parts Book but suggested for 66-69. Fits on end of gas line inside tank, exact fit. C261 2 oz.2B. Gas Tank Sender Unit Float: Slightly different size but fits and works for ALL Corvairs. C846F 4 oz. 2C. Gas Tank Sender Ground Screws : If your gauge isn't working, it might be due to a poor ground. 1960-69 Original Size C5177 1 oz. 1960-69 Oversize for rusted or stripped holes C5178 1 oz.?3. Gauge "Gasket" Seal : 1961-69 rubber seal for tank gauge unit. Replace each time removed. 1961-69 Seal C155 2 oz. 1960 Sender Unit Gasket C3823 1 oz.?4. Strap: Just this one steel strap holds the tank up! 1960-69 Cars: EXACT REPRO C153E 2 lbs. 1960-69 Cars: Good repro C153R 2 lbs. 1961-65 Vans: Good repro (2 needed) C4307 2 lbs.Repro Gas Tank & PartsLow Fuel WarningSee page 98BSteel Gas Lines: See pages 67-68C261C155C7264RC156MULTI-KITSsee Blue pg. MK-4
Search In Corvair Catalog Content
CLARKS- MORE THAN PARTS.

Copyright © 1978, 2022 Clark's Corvair Parts, Inc., "Clark's Corvair Parts" and the "Corvair Map" are registered service marks of Clark's Corvair Parts, Inc.
400 Mohawk Trail Shelburne Falls, MA 01370 USA All rights reserved.
Main Office Phone: 413.625.9776 Fax: 413.625.8498